Subaru Impreza 2002 Service Manual page 3025

BRAKE
B: INSTALLATION
1) Install in the reverse order of removal.
CAUTION:
• If the cable clamp is damaged, replace it with
a new one.
• Never fail to cover the outer cable end with
boot.
• Be careful not to kink the accelerator cable.
• Always use new clevis pins.
2) Adjust the clutch pedal <Ref. to CL-46, AD-
JUSTMENT, Clutch Pedal.>
3) Inspect the brake pedal after installation <Ref. to
BR-68, INSPECTION, Brake Pedal.>
C: DISASSEMBLY
1. LHD 1.6 L MT MODEL
1) Remove the stop light switch.
<Ref. to BR-69, REMOVAL, Stop Light Switch.>
2) Remove the nut and pull out the bolt until brake
pedal is able to remove, then remove brake pedal.
3) Remove the bushing, spring and stopper.
(1) Stopper
(2) Bushing
(3) Brake pedal
(4) Brake pedal spring
4) Remove the brake pad.
BRAKE PEDAL
2. LHD 2.0 L MT MODEL
1) Remove the brake switch.
<Ref. to BR-69, REMOVAL, Stop Light Switch.>
2) Remove the clutch pedal.
<Ref. to CL-43, DISASSEMBLY, Clutch Pedal.>
3) Remove the clutch master cylinder bracket.
4) Remove the bushing, spring and stopper.
BR0069
5) Remove the brake pedal pad.
BR0070
BR-66
(1) Stopper
(2) Bushing
(3) Brake pedal
(4) Brake pedal spring
B4M2349
B4M2350A