Subaru Impreza 2002 Service Manual page 3021

BRAKE
18.Hill Holder
A: REMOVAL
1. PHV (PRESSURE HOLD VALVE)
1) Drain the brake fluid from reservoir of master cyl-
inder.
2) Remove the adjusting nut and lock nut.
(1) Adjusting nut
(2) Lock nut
(3) PHV
3) Remove the cable clamp, and disconnect the
PHV cable from PHV.
CAUTION:
Carefully protect the boots and inner cable
from damage when disconnecting PHV cable.
(1) PHV cable
(2) Clamp
4) Disconnect the brake pipes from PHV.
CAUTION:
• Pay attention not to drop the brake fluid onto
body painting since it may dissolve paint.
• Pay attention not to damage hexagonal head
of the flare nut by using pipe wrench without
fail.
HILL HOLDER
5) Detach the PHV along with support from side
frame.
CAUTION:
Exercise utmost care to prevent foreign matter
from entering into the PHV when removing it.
S4M0241C
2. PHV CABLE
1) Remove the adjusting nut and lock nut.
2) Remove the cable clamp, and disconnect PHV
cable from PHV.
S4M0242C
CAUTION:
Carefully protect the boot and inner cable from
damage when disconnecting PHV cable.
BR-62
(1) PHV
(1) Adjusting nut
(2) Lock nut
(3) PHV
(1) PHV cable
(2) Clamp
S4M0243B
S4M0241C
S4M0242C