Subaru Impreza 2002 Service Manual page 3004

4) Install the brake assembly on housing, and tight-
en the bolts to install back plate.
Tightening torque:
53 N·m (5.4 kgf-m, 39.1 ft-lb)
5) Install the hub. <Ref. to DS-27, INSTALLATION,
Rear Axle.>
6) Connect the brake hose, and tighten the brake
hose flange nut.
Tightening torque:
15 N·m (1.5 kgf-m, 10.8 ft-lb)
7) Connect the ABS sensor to back plate. (only ve-
hicle equipped with ABS)
Tightening torque:
32 N·m (3.3 kgf-m, 24 ft-lb)
8) Apply grease to the adjusting screw and both
ends of adjuster.
Brake grease:
Dow Corning Molykote No. 7439 (Part No.
725191460)
9) Install the brake shoe. <Ref. to BR-42, INSTAL-
LATION, Rear Drum Brake Shoe.>
10) Install the brake drum. <Ref. to BR-43, IN-
STALLATION, Rear Drum Brake Drum.>
11) After installing the brake assembly, bleed air
from the brake line. <Ref. to BR-57, Air Bleeding.>
REAR DRUM BRAKE ASSEMBLY
G4M0400
S4M0457B
BR-45
C: DISASSEMBLY
1) Remove the right and left dust boots from wheel
cylinder.
(1) Bleeder cap
(2) Bleeder screw
(3) Spring
(4) Cylinder
(5) Cup
(6) Piston
(7) Boot
2) Remove the piston, cup, spring and air bleeder
screw and cap.
BRAKE
B4M1126B