Subaru Impreza 2002 Service Manual page 3475

GLASS/WINDOWS/MIRRORS
11) Cut off the cartridge nozzle tip and set it in seal-
ant gun as shown.
12) Apply adhesive to the glass end surface as
shown.
13) Fit the matching pins using suction rubber cup
to install the windshield glass.
14) Lightly press the windshield glass for tight fit.
15) Make the adhesive surface flush using spatula.
CAUTION:
• When the door is opened/closed after glass is
bonded, always lower the door glass and then
open/close it carefully.
• Move the vehicle slowly.
16) After completion of all work, allow the vehicle to
stand for about 24 hours.
NOTE:
For minimum drying time and time the vehicle must
be left standing before driving after bonding, follow
instructions or instruction manual from the adhe-
sive manufacturer.
17) After curing of adhesive, pour water on external
surface of vehicle to check that there are no water
leaks.
CAUTION:
When a vehicle is returned to the user, tell him
or her that the vehicle should not be subjected
to heavy impact for at least three days.
18) Install the cowl panel. <Ref. to EI-32, INSTAL-
LATION, Cowl Panel.>
WINDSHIELD GLASS
G5M0408
G5M0409
GW-28