Subaru Impreza 2002 Service Manual page 3471

GLASS/WINDOWS/MIRRORS
B: INSTALLATION
1) Install in the reverse order of removal.
CAUTION:
Make sure that the glass stay is placed securely
in sash.
2) Adjust the rear door glass. <Ref. to GW-24, AD-
JUSTMENT, Rear Door Glass.>
Tightening torque:
Refer to COMPONENT in General Descrip-
tion. <Ref. to GW-5, REAR DOOR GLASS,
COMPONENT, General Description.> and
<Ref. to GW-4, FRONT DOOR GLASS,
COMPONENT, General Description.>
C: ADJUSTMENT
NOTE:
The rear door glass, as a rule, should be adjusted
in the same manner as front glass, although they
are different in dimension. Special notes for the
rear glass are given below.
1) Adjust the glass position using the following di-
mensions as a guide line.
12 (0.472)
A A
Unit: mm (in)
CAUTION:
• If the dimensions are smaller than the given
dimensions, glass may get caught in weather-
strip during lifting/lowering operation. In the
worst case, it may cause the glass not to be
opened fully.
• After adjustment, move the glass up and
down to check whether it is caught.
REAR DOOR GLASS
12 (0.472)
A-A
BO0394
GW-24
2) Adjust the crimp of glass using the following di-
mensions as a guide line.
A
A
Unit: mm (in)
CAUTION:
• If the crimp of rear glass is higher than nec-
essary, glass may get caught in weatherstrip of
center pillar corner, resulting in early wear of
weatherstrip. Be careful when adjusting.
• After adjustment, move the glass up and
down to check whether it is caught.
2-3
(0.079-0.118)
6 (0.236)
BO0269