Subaru Impreza 2002 Service Manual page 3641

EXTERIOR/INTERIOR TRIM
Pro-
cess Process name
No.
19 Top coat (I)
20 Leave unattended.
21 Top coat (II)
22 Drying
23 Inspection
24 Masking removal
25 Parts installation
26 Bumper installation Install the bumper.
FRONT BUMPER
Solid color
Use a "block" coating method.
• Recommended paint:
Suncryl (SC)
No. 307 Flex Hardener
SC Reducer (thinner)
• Mixing ratio: 3 : 1
Suncryl (SC) vs. No. 307 Flex Hardener
• Viscosity: 11 — 13 sec/20°C (68°F)
• Coated film thickness: 40 — 50µ
• Spraying thickness: 245 — 343 kPa
2
(2.5 — 3.5 kg/cm , 36 — 50 psi)
Not required.
Not required.
Allow the coated surface to dry at 20°C (68°F) for two hours or 60°C (140°F) for 30 minutes.
NOTE:
Do not allow the temperature to exceed 80°C (176°F) since this will deform the PP substrate.
Carefully check the condition of the repaired area.
Remove the masking tape applied in Process No. 11 and 13.
Install the parts on bumper in reverse order of removal.
Job contents
Use a "block" coating method.
• Recommended paint:
Suncryl (SC)
No. 307 Flex Hardener
SC Reducer (thinner)
• Mixing ratio: 3 : 1
Suncryl (SC) vs. No. 307 Flex Hardener
• Viscosity: 11 — 13 sec/20°C (68°F)
• Coated film thickness: 20 — 30µ
• Spraying thickness: 245 — 343 kPa
(2.5 — 3.5 kg/cm
Leave unattended at 20°C (68°F) for at least 10
minutes until the topcoated area is half-dry.
NOTE:
Be careful to keep dust or dirt from coming in
contact with the affected area.
Apply a clear coat three times at an interval of 3
to 5 minutes.
• Recommended paint:
SC710 Overlay Clear
No. 307 Flex Hardener
SC Reducer (thinner)
• Mixing ratio: 3 : 1
Suncryl (SC) vs. No. 307 Flex Hardener
• Viscosity: 10 — 13 sec/20°C (68°F)
• Coated film thickness: 20 — 30µ
• Spraying pressure: 245 — 343 kPa
(2.5 — 3.5 kg/cm
EI-28
Metallic color
2
, 36 — 50 psi)
2
, 36 — 50 psi)