Subaru Impreza 2002 Service Manual page 2993

BRAKE
B: INSTALLATION
1. 14 INCH TYPE
1) Apply a thin coat of Molykote AS880N (Part No.
26298AC000) to the frictional portion between pad
and pad clip.
2) Install the pad on support.
3) Install the caliper body on support.
Tightening torque:
39 N·m (4.0 kgf-m, 28.9 ft-lb)
NOTE:
If it is difficult to push the piston during pad replace-
ment, loosen air bleeder to facilitate work.
2. 15 INCH TYPE
1) Apply a thin coat of Molykote AS880N (Part No.
26298AC000) to frictional portion between pad and
pad inner shim.
2) Install the pads on caliper body.
3) Install the cross spring.
4) Install the pad pins on caliper body.
5) Install the M clip.
C: INSPECTION
1. 14 INCH TYPE
Check pad thickness A.
Pad thickness Standard value
(including back
Wear limit
metal)
CAUTION:
• Always replace the pads for both right and
left wheels at the same time. Also replace the
pad clips if they are twisted or worn.
• A wear indicator is provided on the inner disc
brake pad. If the pad wears down to such an ex-
tent that the end of wear indicator contacts disc
rotor, a squeaking sound is produced as the
wheel rotates. If this sound is heard, replace the
pad.
• Replace the pad if there is oil or grease on it.
REAR BRAKE PAD
S4M0187A
14.0 mm (0.551 in)
6.5 mm (0.256 in)
BR-34
2. 15 INCH TYPE
Check the pad thickness A.
Pad thickness Standard value
(including back
Wear limit
metal)
CAUTION:
• Always replace the pads for both right and
left wheels at the same time. Also replace the
pad clips if they are twisted or worn.
• A wear indicator is provided on the inner disc
brake pad. If the pad wears down to such an ex-
tent that the end of wear indicator contacts disc
rotor, a squeaking sound is produced as the
wheel rotates. If this sound is heard, replace the
pad.
• Replace the pad if there is oil or grease on it.
A
BR0021
16.0 mm (0.63 in)
6.0 mm (0.236 in)