Subaru Impreza 2002 Service Manual page 3041

PARKING BRAKE ASSEMBLY (REAR DISC BRAKE)
PARKING BRAKE
B: INSTALLATION
CAUTION:
Be sure the lining surface is free from oil con-
tamination.
Brake grease:
Dow Corning Molykote No. 7439 (Part No.
725191460)
1) Apply brake grease to the following places.
• Six contact surfaces of shoe rim and back plate
packing
• Contact surface of shoe wave and anchor pin
• Contact surface of lever and strut
• Contact surface of shoe wave and adjuster as-
sembly
• Contact surface of shoe wave and strut
• Contact surface of lever and shoe wave
2) Install in reverse order of removal.
CAUTION:
• Use new retainers and clinch them when in-
stalling the brake shoes to levers.
• Ensure that the parking lever moves smooth-
ly.
• Do not confuse the left parking lever with
right one.
• Do not confuse the left strut with right one.
NOTE:
Ensure that the adjuster assembly is securely in-
stalled with screw in the left side, facing vehicle
front.
(1) LEFT
NOTE:
Ensure that the shoe return spring is installed as
shown in the figure.
3) Adjust the parking brakes. <Ref. to PB-11, AD-
JUSTMENT, Parking Brake Assembly (Rear Disc
Brake).>
CAUTION:
After replacing the parking brake lining, be sure
to drive the vehicle for "break-in" purposes.
(1) Drive the vehicle at about 35 km/h (22 MPH).
(2) With the parking brake release button
pushed in, pull the parking brake lever gently.
(3) Drive the vehicle for about 200 meter (0.12
mile) in this condition.
(4) Wait 5 to 10 minutes for the parking brake to
cool down. Repeat this procedure once more.
(5) After breaking-in, re-adjust the parking
brakes.
S4M0461A
PB-10
(1) Back plate
(2) Shoe guide plate
(3) Retainer
(4) Spring washer
(5) Lever
(6) Primary shoe return spring (Blue)
(7) Secondary shoe return spring (Yellow)
(8) Parking brake shoe (Primary)
(9) Parking brake shoe (Secondary)
S4M0462A