Subaru Impreza 2002 Service Manual page 3000

8. Rear Drum Brake Shoe
A: REMOVAL
1) Loosen the wheel nuts, jack-up the vehicle, sup-
port it with rigid racks, and remove the wheel.
2) Release the parking brake.
3) Remove the brake drum from brake assembly.
NOTE:
• If it is difficult to remove the brake drum, remove
the adjusting hole cover from back plate, and then
turn adjuster assembly pawls using a slot-type
screwdriver until brake shoe separates from the
drum.
(1) Back plate
(2) Wheel cylinder
(3) Adjuster ASSY pawls
(4) Adjusting lever
(5) Tightening direction
(6) Push.
• If the brake drum is difficult to remove, drive it out
by installing an 8-mm bolt into bolt hole in brake
drum.
REAR DRUM BRAKE SHOE
4) Hold the hold-down pin by securing rear of back
plate with your hand.
5) Disconnect the hold-down cup from hold-down
pin by rotating hold-down cup.
6) Disconnect the lower shoe return spring from
shoes.
S4M0369A
7) Remove the shoes one by one from back plate
with adjuster.
CAUTION:
Be careful not to bend the parking brake cable
excessively when removing brake shoes.
B4M0243
BR-41
(1) Hold-down cup
(2) Hold-down pin
(1) Wheel cylinder
(2) Adjuster
(3) Back plate
(4) Lower shoe return spring
(5) Parking lever
(6) Trailing shoe
BRAKE
S4M0451A
S4M0452
S4M0453A