Subaru Impreza 2002 Service Manual page 3611

SUNROOF/T-TOP/CONVERTIBLE TOP (SUNROOF)
5. Sunroof Motor
A: REMOVAL
CAUTION:
When removing the clip, use great care to not
damage the roof trim.
1) Disconnect the ground cable from battery.
2) Completely close the sunroof.
3) Remove the sunroof lid. <Ref. to SR-5, REMOV-
AL, Sunroof Lid.>
4) Confirm the matching mark (A) of sunroof brack-
et link and the guide from sunroof opening. (If the
mark does not match, adjust to match the mark.)
5) Remove the roof trim. <Ref. to EI-48, REMOV-
AL, Roof Trim.>
6) Remove the motor cover.
7) Disconnect the harness connector and remove
the sunroof motor mounting screw.
SUNROOF MOTOR
B: INSTALLATION
CAUTION:
• Never rotate the sunroof motor while re-
moved.
• Be careful not to move the sunroof cable
when installing sunroof motor.
1) Check the matching mark (A) of sunroof motor.
2) Confirm the matching mark (A) of sunroof brack-
et link.
B5M1036A
3) Install the sunroof motor.
4) After installing the motor, reconfirm the matching
marks of motor side and sunroof bracket link side.
5) Connect the sunroof motor harness connector
and then connect the battery ground cable.
6) Check the sunroof operation with the procedure
BO0139
as shown in the table.
(1) Completely close sunroof.
(2) Tilt-up sunroof to most upper position.
(3) Lower sunroof completely.
(4) Open sunroof to near the completely
open position.
(5) Completely open sunroof.
(6) Close sunroof 150 mm (5.91 in) away
from completely closed position.
(7) Completely close sunroof.
7) Install the sunroof lid and trims in the reverse or-
der of removal.
SR-8
Operation
BO0144
B5M1036A
Switch position
Closed
Tilt-up
Tilt-down
Open
Open
Closed
Closed