Subaru Impreza 2002 Service Manual page 3684

6. Rear Door Panel
A: REMOVAL
CAUTION:
• During removal and installation of doors, do
not damage the body.
• Doors are heavy. Be careful not to drop and
damage them.
1) Disconnect the ground cable from battery.
2) Remove the rear door trim. <Ref. to EI-37, RE-
MOVAL, Rear Door Trim.>
3) Remove the rear door glass. <Ref. to GW-23,
REMOVAL, Rear Door Glass.>
4) Remove the rear door regulator and motor as-
sembly. <Ref. to GW-25, REMOVAL, Rear Regula-
tor and Motor Assembly.>
5) Remove the rear door latch. <Ref. to SL-24, RE-
MOVAL, Rear Door Latch Assembly.>
6) Remove the rear outer handle. <Ref. to SL-23,
REMOVAL, Rear Outer Handle.>
7) Remove the center pillar lower trim. <Ref. to EI-
45, REMOVAL, Lower Inner Trim.>
8) Disconnect the connector of door harness.
9) Put a wooden block on the jack and place the
jack under the door. Support the door with the jack
to protect it.
REAR DOOR PANEL
10) Remove the checker bolts.
11) Remove the door-side bolts for upper and low-
er hinges to remove the door.
B: INSTALLATION
1) Install in the reverse order of removal.
2) Apply grease to the sliding area of door hinges.
Tightening torque:
Refer to COMPONENT in General Descrip-
tion.
<Ref. to EB-6, REAR DOOR PANEL,
BO0154
COMPONENT, General Description.>
S5M0518
EB-15
EXTERIOR BODY PANELS
S5M0183
G5M0385