Subaru Impreza 2002 Service Manual page 3106

9) Install the holder from cylinder side of steering
body.
Tightening torque:
64 N·m (6.5 kgf-m, 47.0 ft-lb)
10) Attach the ST to rack cylinder. Using a press,
install the back-up ring and oil seal.
NOTE:
Press the ST until its groove is aligned with end of
holder.
ST 34099FA030 INSTALLER & REMOVER
(1) Installer guide
(2) Holder
(3) Rack piston
(4) Oil seal
(5) Back-up ring
STEERING GEARBOX [RHD MODEL]
G4M0820
S4M0433A
PS-63
POWER ASSISTED SYSTEM (POWER STEERING)
11) Using the ST, clinch steering body cylinder at a
point less than 3 mm (0.12 in) from holder.
CAUTION:
Be careful not to deform the holder.
ST 34099FA060 PUNCH HOLDER
12) Roll the vinyl tape on serration part of valve as-
sembly, and then apply grease on the tape surface.
(1) Vinyl tape
S4M0434B
B4M2610A