Subaru Impreza 2002 Service Manual page 3374

Hide thumbs Also See for Impreza 2002:
Table of Contents

Advertisement

5. Disposal of Pretensioner
A: CAUTION
• Do not discard undeployed pretensioners, be-
cause they may cause serious personal injury
when accidentally deployed.
• Deployment of the pretensioners should be done
on a flat place free from any possible danger. Avoid
deploying outdoors during rainy or windy weather.
• Do not drop or damage the pretensioner.
• Because deploying the pretensioners causes a
high-explosive noise, be sure to warn people in the
area, and do not allow anyone within a 5-meter (16
ft) radius of the disposal site.
• Some smoke will be emitted after deployment of
the pretensioners. Therefore, it must be deployed
in a well-ventilated area with no smoke alarms
nearby.
• Wear gloves, goggles, and earplugs during this
operation. Wash your hands afterwards.
• After deployment, the pretensioner is especially
hot. Leave it unattended for 40 minutes, and then
discard it.
• Do not let water get on the deployed pretension-
er.
• Wrap the deployed pretensioner in an airtight vi-
nyl bag, and then discard it.
• If circumstances do not permit pretensioner de-
ployment, contact a SUBARU dealer.
B: OPERATION
1. DEPLOYING WHILE INSTALLED IN VE-
HICLE
1) Fold backrest all the way forward, and then
move front seat all the way forward.
2) Turn the ignition switch to OFF, disconnect the
ground cable from battery, and wait for more than
20 seconds before starting work.
3) Remove the center pillar lower trim. <Ref. to EI-
45, REMOVAL, Lower Inner Trim.>
4) Disconnect the yellow connector from preten-
sioner (a).
5) Short the terminal to alligator clip furnished as
deployment tool (A).
DISPOSAL OF PRETENSIONER
B5M0918A
SB-13
6) Connect the deployment tool and adapter C (de-
ployment) (B).
CAUTION:
The deployment tool should be kept shorted
until just before deployment of the pretension-
er.
(A) Deployment tool: (Part No. 98299PA030)
(B) Adapter C (deployment): (Part No.
98299FE010)
7) Connect the adapter A (deployment) connector
and pretensioner yellow connector.
8) Extend the deployment tool to the limit, and
make sure that the vehicle is empty. Close all win-
dows, sunroof, and rear gate completely.
9) Move the battery at least 5 m (16 ft) from the vehi-
cle, and secure the nearby area. Connect the de-
ployment tool alligator clip to the battery negative (−)
terminal.
SEAT BELT SYSTEM
S5M0309B
B5M1068

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents