Subaru Impreza 2002 Service Manual page 3124

8. Pipe Assembly [RHD MODEL]
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Lift-up the vehicle, and then remove the jack-up
plate.
(1) Jack-up plate
3) Remove the one pipe joint at the center of gear-
box, and then connect the vinyl hose to pipe and
joint. Discharge fluid by turning steering wheel fully
clockwise and counterclockwise. Discharge fluid
similarly from the other pipe.
CAUTION:
Improper removal and installation of the parts
often causes fluid leak trouble. To prevent this,
clean the surrounding portions before disas-
sembly and reassembly, and pay special atten-
tion to keep dirt and other foreign matter from
mating surfaces.
(1) Pipe A
(2) Pipe B
PIPE ASSEMBLY [RHD MODEL]
S4M0380A
ST0008
PS-81
POWER ASSISTED SYSTEM (POWER STEERING)
4) Remove the clamp E from pipes C and D.
(1) Return hose
(2) Pressure hose
(3) Clamp E
5) Disconnect the pipes C and D from pipe (on the
gearbox side).
CAUTION:
• When disconnecting the pipes C and D, use
two wrenches to prevent deformities.
• Be careful to keep the pipe connections free
from foreign matter.
(1) Pipe C
(2) Pipe D
B4M2509A
ST0051