Subaru Impreza 2002 Service Manual page 3518

COMBINATION METER ASSEMBLY
INSTRUMENTATION/DRIVER INFO
3. Combination Meter Assem-
bly
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Set the tilt steering at lowest position.
3) Remove the screws and detach meter visor.
: Hook pawl
BO0012
4) Remove the screws of combination meter and
pull out the meter toward you.
BO0013
5) Disconnect the connector in the upper area of
combination meter to remove meter.
CAUTION:
• Be careful not to damage the meter or instru-
ment panel.
• Pay particular attention to avoid damaging
the meter glass.
B: INSTALLATION
Install in the reverse order of removal.
CAUTION:
• Make sure that electrical connector is con-
nected securely.
• Make sure that each meter operates normally.
IDI-15