Subaru Impreza 2002 Service Manual page 3711

CRUISE CONTROL SYSTEM (DIAGNOSTICS)
6) Turn the Subaru Select Monitor switch to ON.
7) On the Main Menu display screen, select the {All
System Diagnosis} and press [YES] key.
NOTE:
The diagnostic trouble code (DTC) is also shown in
the {Each System Check} mode. This mode is
called up on the Cruise Control Diagnosis screen
by selecting the item {Cancel Code(s) Display}.
8) Drive the vehicle at least 30 km/h (19 MPH) with
cruise speed set.
9) If the cruise speed is canceled itself (without do-
ing any cancel operations), a diagnostic trouble
code (DTC) will appear on select monitor display.
CAUTION:
• A diagnostic trouble code (DTC) will also ap-
pear when cruise cancel is effected by driver.
Do not confuse.
• Have a co-worker ride in the vehicle to assist
in diagnosis during driving.
NOTE:
Diagnostic trouble code (DTC) will be cleared by
turning the ignition switch or cruise control main
switch to OFF.
SUBARU SELECT MONITOR
3. REAL-TIME DIAGNOSIS
1) Connect the select monitor.
2) Turn the ignition switch and cruise control main
switch to ON.
3) Turn the Subaru Select Monitor switch to ON.
4) On the Main Menu display screen, select the
{Each System Check} and press [YES] key.
5) On the System Selection Menu display screen,
select the {Cruise Control} and press [YES] key.
6) Press the [YES] key after displayed the informa-
tion of engine type.
S2M0288A
7) On the Cruise Control Diagnosis display screen,
select the {Current Data Display & Save} and press
[YES] key.
8) Make sure that normal indication is displayed
when controls are operated as indicated below:
• Depress/release the brake pedal. (Stop light
switch and brake switch turn ON.)
• Turn ON the "SET/COAST" switch.
• Turn ON the "RESUME/ACCEL" switch.
• Depress/release the clutch pedal. (MT)
• Set the selector lever to P or N. (AT)
NOTE:
• For detailed operation procedure, refer to the
SUBARU SELECT MONITOR OPERATION MAN-
UAL.
• For detailed concerning diagnostic trouble codes
(DTCs), refer to the List of Diagnostic Trouble Code
(DTC).
<Ref. to CC-28, List of Diagnostic Trouble Code
(DTC).>
CC-12