Connecting Hydraulics - MacDon R113 Operator's Manual

3.8.3 Connecting Hydraulics

WARNING
Do NOT use remote hydraulic system pressures over 3000 psi (20,684 kPa). Check your tractor operator's
manual for remote system pressure.
NOTE:
Refer to colored bands on hoses to identify lift, steering/transport, and tilt hose sets.
Table 3.4 Hydraulic System Hoses
System
(1 hose standard
Lift
2 hoses with
ETO installed)
Steering and
Transport
Mower
Conditioner Tilt
1. Connect one LIFT cylinder hose (A) (two hoses
required if endwise transport system installed) to
activate the following tractor hydraulic controls:
Table 3.5 Lift System
Control Lever
Position Movement
Forward
Backward
2. Connect two STEERING cylinder hoses (B) to activate
the following tractor hydraulic controls:
Table 3.6 Steering and Transport System
Control Lever
Position Movement
Forward
Backward
169820
Tractor
Hose
Hydraulics
A
Control 1
B
Control 2
(2 hoses)
C
Control 3
(2 hoses)
Mower
Cylinder
Conditioner
Movement
Retract Lower
Extend Raise
Mower
Cylinder
Conditioner
Direction
Extend Right
Retract Left
OPERATION
Figure 3.34: Hydraulic Connections
49
Revision A