Configuring An Ipv4 Basic Acl; Configuring An Ipv6 Basic Acl - HPE FlexNetwork 5510 HI Series Acl And Qos Configuration Manual

Configuring an IPv4 basic ACL

IPv4 basic ACLs match packets based only on source IP addresses.
To configure an IPv4 basic ACL:
Step
1. Enter system view.
2. Create an IPv4 basic ACL
and enter its view.
3. (Optional.)
description for the IPv4 basic
ACL.
4. (Optional.)
numbering step.
5. Create or edit a rule.
6. (Optional.) Add or edit a rule
comment.

Configuring an IPv6 basic ACL

IPv6 basic ACLs match packets based only on source IP addresses.
To configure an IPv6 basic ACL:
Step
1. Enter system view.
2. Create an IPv6 basic ACL
view and enter its view.
3. (Optional.)
description for the IPv6 basic
ACL.
4. (Optional.)
numbering step.
5. Create or edit a rule.
Command
system-view
acl number acl-number [ name
acl-name ] [ match-order { auto |
config } ]
Configure a
description text
Set the rule
step step-value
rule [ rule-id ] { deny | permit }
[ counting | fragment | logging |
source
source-wildcard
time-range time-range-name |
vpn-instance
vpn-instance-name ] *
rule rule-id comment text
Command
system-view
acl ipv6 number acl-number
[ name acl-name ] [ match-order
{ auto | config } ]
Configure a
description text
Set the rule
step step-value
rule [ rule-id ] { deny | permit }
{ source-address
| any } |
4
Remarks
N/A
By default, no ACL exists.
IPv4 basic ACLs are numbered in
the range of 2000 to 2999.
You can use the acl name
acl-name command to enter the
view of a named ACL.
By default, an IPv4 basic ACL has
no ACL description.
The default setting is 5.
By default, an IPv4 basic ACL
does not contain any rule.
The logging keyword takes effect
only when the module
example, packet filtering) that
uses the ACL supports logging.
If an ACL is for outbound QoS
traffic classification or outbound
packet filtering, do not specify the
vpn-instance keyword.
By default, no rule comments are
configured.
Remarks
N/A
By default, no ACL exists.
IPv6 basic ACLs are numbered in
the range of 2000 to 2999.
You can use the acl ipv6 name
acl-name command to enter the
view of a named ACL.
By default, an IPv6 basic ACL has
no ACL description.
The default setting is 5.
By default, an IPv6 basic ACL
(for