VTech ET685 Administrator And Provisioning Manual page 385

Default:
Setting:
Description:
Values:
Default:
Setting:
Description:
Values:
Default:
Setting:
Description:
Configuration File Parameter Guide
ET685 Administrator and Provisioning Manual
blank
user_default_contact_uri
OCS offers the user the possibility of publishing additional phone numbers
under which he or she is reachable. This information will published along
with the user's presence information. When traversing a contact list on a
VTech phone, a contact may be called by selecting it (i.e. scrolling until it
is highlighted) and then pressing 'enter' or going offhook. By default, the
contact's SIP URI is used to place the call. This setting allows the default
to be changed to one of the published phone numbers. This is paricularly
usefull in environments where OCS is used for presence only and voice is
routed over a different server, as the OCS SIP URI cannot be used in this
case to establish a voice call.
This setting is used by server directories such as Metaswitch, LDAP,
Broadsoft XSI and Broadsoft Xmpp Contacts to control the behavior when
user presses OK on a contact:
If set to "none" (default), bring up the Contact Details screen of the

contact.
If set to "main", directly dial the number that is considered the main

one of the contact.
none, main
none
user_descr_contact
When your SIP Registrar is not properly supporting long contacts specified
in accordance with RFC 3840, you may want to switch this behavior off.
on, off
on
user_dp_exp
ENUM means that a conventional E.164 number (normal phone number)
is mapped to a SIP URI so that a pure IP call can be started instead of an
IP/PSTN call. To use ENUM lookup not only this option has to be enabled,
but also below options Countrycode and Areacode have to be setup
properly before. Both options are used to build the above Dial Plan String
which is mandatory to make the ENUM lookup work.
385
Back to Contents