VTech ET685 Administrator And Provisioning Manual page 161

Setting
Zone (1-10) - IP Address
Web User Interface (WebUI) Reference
ET685 Administrator and Provisioning Manual
Description
The phone receives RTP packets destined for this multicast
IP address and port and plays them out.
Starting at version 8.7.3.26 you can setup the multicast
address with additional options:
speaker=(0|1):

If this option is set and value is 1, then the multicast
audio will be played always over speaker. If value is
0, then the current audio device will be used. If this
option is not set, then value 0 is used as default
value.
interrupt=(0|1):

If this option is set and value is 1, then the multicast
audio interrupts a running call. If multicast is
finished, then the interrupted call continues. If value
is 0, the multicast audio will only be played in idle
state. If this option is not set, then value 0 is used as
default value.
volmax=(0|1):

If this option is set and value is 1, then the maximal
volume will be used for multicast audio. If value is 0,
then the current volume will be used. If this option is
not set, then value 0 is used as default value.
priority=(0..10):

This option sets the priority of the multicast address.
You can choose a priority between 0 and 10, where
0 is the lowest and 10 the highest priority. If the
phone receives multicast from more than one
configured port, then the multicast with the highest
priority will be played. If they have the same priority
then the multicast will be played, that was received
first. If this option is not set, then a priority of 5 is
used as default.
Please note: for hold scenarios an incoming multicast is
blocked with cw_dialtone = on (default). In case it's required
to received the multicast also if calls on, please set this to
off.
161
Back to Contents