VTech ET685 Administrator And Provisioning Manual page 147

Setting
Intercom Policy
Show display name in
Dialog-Info
Call join on Xfer (2 calls)
Call Join on Transfer
Web User Interface (WebUI) Reference
ET685 Administrator and Provisioning Manual
Description
Incoming intercom-calls (i.e. those that use the Alert-Info
SIP header, see intercom) do not ring but go directly to
connected. That is if the situation and this setting allow it.
off - will disable auto-connect

always - will enable auto-connect without

restrictions
idle - will allow auto-connect only when phone is in

idle-screen
not_busy - will allow auto-connect except for when

the user is in an active call, i.e. holding a call will
allow for intercom-interuptions, while any call in one
of the following states will disable auto-connect:
ringing, calling, connected, being held by the other
call-partner.
When this setting is turned on, the call monitoring state
shows display names for remote and local users found in
the body of incoming dialog info notifies, as long as the
display_method setting is set to name as well. If this setting
is turned off, the user name in the uri's will be shown to
maximize display space.
When this feature is turned "on" and you have exactly one
person on hold, pressing transfer while in a call to another
person will result in an immediate transfer of him/her to the
held party. In the same scenario with this feature turned off
or in scenarios with multiple parties on hold, you will be
asked where to transfer to. You can then select between all
the other calls you currently have and entering a number
manually (blind transfer).
When this feature is turned "on" and you have exactly one
person on hold, pressing transfer while in a call to another
person will result in an immediate transfer of him/her to the
held party. If it is set to "always" the immediate transfer is
invoked also if there is more than one call on hold. In this
case the transfer target is either the first or the last call to be
put on hold, depending on the setting xfer_dest_order_lifo.
In the same scenario with this feature turned off, you will be
asked where to transfer to. You can then select between all
the other calls you currently have and entering a number
manually.
147
Back to Contents