VTech ET685 Administrator And Provisioning Manual page 194

Description:
Values:
Default:
Setting:
Description:
Values:
Default:
Setting:
Description:
Configuration File Parameter Guide
ET685 Administrator and Provisioning Manual
For security reasons this setting disables the possibility to send XML
settings via SIP MESSAGE. If it is "on", the phone accepts settings via
SIP MESSAGE. If it is "off", the phone just sends a 200 OK but does not
take over the settings. If enabled one must provide a secure environment.
The SIP MESSAGE method is used to send settings. A SIP MESSAGE
must have the following two headers, otherwise it is ignored for this
purpose.
Content-Type: application/xml
Event: vtech-settings
The body of the SIP message contains XML like:
<settings>
<phone-settings>
<setting_name>setting_value</setting_name>
...
</phone-settings>
</settings>
on, off
off
allow_sip_xml_action
For security reasons this setting disables the possibility to parse
vtech-XMLs received via SIP MESSAGE. When activated the phone
accepts an entire xml-configuration within special SIP MESSAGEs. If it is
"off", the phone just sends a 200 OK but does not parse the
xml-configuration. If enabled one should provide a secure environment.
A SIP MESSAGE must have the following two headers, otherwise it is
ignored for this purpose.
Content-Type: application/xml
Event: vtech-action
The body of the SIP message contains an xml as described here. Most
likely one would make it contain only an action-section that holds one or
more actions that fire "on notify"
on, off
off
allow_wizard_abort
Turn this setting on if you want to abort the logon or initial setup wizard.
Switch it off if you want only a system information. To abort a wizard make
a long press on the 'cancel' key.
194
Back to Contents