VTech ET685 Administrator And Provisioning Manual page 335

Description:
Values:
Default:
Setting:
Description:
Values:
Default:
Setting:
Description:
Values:
Default:
Setting:
Description:
Values:
Default:
Configuration File Parameter Guide
ET685 Administrator and Provisioning Manual
This value specifies after how many seconds the phone should attempt to
reregister when the initial registration has failed. If this value is zero, the
phone will make no such attempt.
Value can be single integer value (range '1' to this value) or a range like
'2,10'. Randomizing 10 percent if single value is configured (e.g. 300 +-
30sec)
The value can also be, for example '3,6:300'. In this case when the phone
loses the registration, a random value in seconds between 3 and 6 will be
chosen and after this time the phone will try again. After that the value is
doubled and the phone will try again until registration succeeds or the timer
rechaed the second value. This is the maximum timer value. So basically
the longer the phone is unregistered the longer it takes to reregister.
1 - 1209600
300
retry_after_failed_subscribe
When subscription fails this settings describes the value in seconds after
which the phone will try again.
Be aware: don't confuse this setting with the SUBSCRIBE expiration,
which is defined by setting user_subscription_expiry
Positive Integer
600
ring_after_delay
The phone delays playing the ringer for the given amount of seconds. But
the message LED still rings from the beginning.
Integer, blank
blank
ring_count
This setting is used for synchronisation of Call Forwarding
Timeout/NoAnswer for Broadsoft.
Integer
5
335
Back to Contents