VTech ET685 Administrator And Provisioning Manual page 150

Setting
Show Desktop Message
in Call Screens
Prefer local Photos
Keys:
Transfer on Onhook
Independent transfer on
Onhook
Transfer starcode picked
up calls
Quick Transfer to Speed
Dial/Extension
Web User Interface (WebUI) Reference
ET685 Administrator and Provisioning Manual
Description
Messages received via SIP MESSAGE outside an INVITE
are displayed on the desktop of the idle screen. When this
setting is enabled, the message will also appear in call
screens.
NOTE: Messages received inside an INVITE dialog are only
displayed in the 'connected' screen.
This setting is used to decide which photo to show, when
you have a photo in your local address book and the server
sends another one over in the SIP INVITE package.
See also Caller Picture.
If you want to transfer two calls by placing the handset
onhook (one incoming call and one outgoing call), you can
switch it on here.
If you want to transfer two calls by placing the handset
onhook (independent of call direction (incoming / outgoing):
that will be not a Plain Old Telephone Service pots) , you can
switch it on here. Condition: transfer_on_hangup must be
set to on.
If setting 'transfer on hangup' is set to on and the first call
was picked up with a PBX starcode then the transfer will be
done if this setting is set to on. Info: a picked up call with
starcode is an outgoing call. But an incoming and an
outgoing call is the condition for the 'transfer on hangup'.
If set to New Call, pressing a Speed Dial / BLF / Extension
/ BLF (Server) key during call active will put the active call
on hold and a new call will be initiated dialing out to the
configured number associated with the key.
If set to Blind Transfer, pressing a Speed Dial / BLF /
Extension / BLF (Server) key during call active will blind
transfer the active call to the configured number associated
with the key.
If set to Attended Transfer, pressing a Speed Dial / BLF /
Extension / BLF (Server) key during call active will put the
active call on hold and initiate a new call to the configured
number for attended transfer. User can complete the
transfer as early attended or attended transfer via the
"Transfer" key.
150
Back to Contents