VTech ET685 Administrator And Provisioning Manual page 195

Values:
Default:
Setting:
Description:
Values:
Default:
Setting:
Description:
Values:
Default:
Setting:
Description:
Values:
Default:
Configuration File Parameter Guide
ET685 Administrator and Provisioning Manual
on, off
on
always_delegate_forward
This setting is only available for LYNC. It can make a delegate always
reachable on behalf of the boss. Even if the Boss turns of call
forwarding/simultaneous ringing, we reset to call forwarding on if
always_deleg_forw is active. If always_deleg_sim is active, we reset to
simultaneous ringing.
on, off
off
always_show_active_call
This setting is used to configure the default behaviour in call waiting
scenarios. Default value on will keep the active call on the display,
regardless of any incoming calls. All user actions such as hold or transfer
will effect the active call. Disabling this setting will display the latest
incoming call (all actions will be applied to the call displayed)
on, off
on
answer_after_policy
Incoming intercom-calls (i.e. those that use the Alert-Info SIP header) do
not ring but go directly to connected. That is if the situation and this
setting allow it.
off - will disable auto-connect

always - will enable auto-connect without restrictions

idle - will allow auto-connect only when phone is in idle-screen

not_busy - will allow auto-connect except for when the user is in

an active call, i.e. holding a call will allow for intercom-interuptions,
while any call in one of the following states will disable
auto-connect: ringing, calling, connected, being held by the other
call-partner.
off, idle, not busy, always
off
195
Back to Contents