VTech ET685 Administrator And Provisioning Manual page 159

Setting
Release Transferred
Party On
Retrieve Transferred
Party On
Allow SIP Settings
Minibrowser:
XML NOTIFY Support
RTP/RTCP:
Dynamic RTP port start
Web User Interface (WebUI) Reference
ET685 Administrator and Provisioning Manual
Description
When a call is transferred, the transferred party sends
notifications to the tranferring party about the progess of the
call towards the transfer target. The notifications include the
current SIP response code received by the transferred
party. This settings specifies at which point the transferring
party will release the transferred call. This occurs when the
reported SIP response code is equal to or greater than the
value of this setting. This setting should be administered in
tandem with the setting retrieve_xferred_call_on. Note that
when marking a call with save transfer the phone will ignore
the actuall setting value and instead act as if this was set to
200.
When a call is transferred, the transferred party sends
notifications to the tranferring party about the progess of the
call towards the transfer target. The notifications include the
current SIP response code received by the transferred
party. This settings specifies at which point the transferring
party will deem the transfer failed and retrieve the
transferred call (which up to this point is still on hold). This
occurs when the reported SIP response code is equal to or
greater than the value of this setting. This setting should be
administered in tandem with the setting
release_xferred_call_on. Note that when marking a call with
save transfer the phone will ignore the actuall setting value
and instead act as if this was set to 200.
For security reasons this setting disables the possibility to
send XML settings via SIP MESSAGE. If it is on, the phone
accepts settings via SIP MESSAGE. If it is off, the phone
just sends a 200 OK but does not take over the settings. If
enabled one must provide a secure environment. The SIP
MESSAGE method is used to send settings. A SIP
MESSAGE must have the following two headers, otherwise
it is ignored for this purpose.
Content-Type: application/xml
Event: vtech-settings
Enables/Disables xml notifies (type: application/ciscoxml
OR application/vtechxml).
If you want to set up the port range out of which the RTP
ports will be dynamically taken, specify the start port number
in this field.
159
Back to Contents