VTech ET685 Administrator And Provisioning Manual page 199

Setting:
Description:
Values:
Default:
Setting:
Description:
Values:
Default:
Setting:
Description:
Values:
Default:
Setting:
Description:
Values:
Configuration File Parameter Guide
ET685 Administrator and Provisioning Manual
auto_logoff_time
After turning back to idle state and specified amount of time in minutes, all
identities are removed.
integer
blank
auto_reboot_on_setting_change
This setting may be used to enable the auto reboot feature during
provisioning but preserve old behaviour if needed. Some settings need a
reboot to get applied (i.e. vlan, dhcp, ip_address, etc.).
When using this setting in the provisioning file, please remember:
A change of this setting takes effect on the settings following

it in the provisioned settings file only, so if you like to have it
effect all settings in the provisioned settings file, put it at the
top of the file.
This is a setting just like any other setting. If this setting is

turned on, it stays on. So after a reboot, the setting is still on,
even if it isn't mentioned at all in the new settings file. If you
experience a constantly rebooting phone, set log level to 7
and see (via syslog server) which setting causes the loop.
on, off
off
auto_redial
In case of busy signal, the phone will make an automatic attempt to redial
the same number if this setting is turned on. The redial time is dependent
on the parameter auto_redial_value.
on, off
off
auto_redial_value
If the parameter auto_redial is on, the value of this setting is used to
redial the same number in case of busy signal.
integer
199
Back to Contents