Torque Limit Value Change Request Instruction From The Plc Cpu To The Motion Cpu - Mitsubishi Electric Q172CPU Programming Manual

4 MOTION DEDICATED PLC INSTRUCTION

4.6 Torque Limit Value Change Request Instruction from The PLC CPU to The Motion CPU:

S(P).CHGT (PLC instruction:
Internal devices
(System, User)
Bit Word
(n1)
(S1)
(S2)
(D1)
(D2)
[Instruction]
[Setting data]
Setting data
(n1)
(S1)
(S2)
(D1)
(D2)
(Note-1) : Motion CPU cannot used CPU No.1 in the Multiple CPU configuration.
(Note-2) : "n" shows the numerical value which correspond to axis No..
S(P) .CHGT
• Torque limit value change request instruction from the PLC CPU to the Motion CPU
(S(P).CHGT)
Bit
File
digit
register
specified
[Condition]
Start request
SP.CHGT
Start request
S.CHGT
(First I/O No. of the target CPU)/16
Value to specify actually is the following.
CPU No.2 : 3E1H, CPU No.3 : 3E2H, CPU No.4 : 3E3H
(Note-2)
Axis No.("Jn")
Q173CPU(N) : J1 to J32/Q172CPU(N) : J1 to J8
Setting of the torque limit value change to change.
Complete devices
(D1+0) : Device which make turn on for one scan at start accept completion of
instruction.
(D1+1) : Device which make turn on for one scan at start accept abnormal
completion of instruction.
("D1+0" also turns on at the abnormal completion.)
Device to store the complete status.
Q173CPU(N) : Axis No.1 to No.32 (n=1 to 32) / Q172CPU(N) : Axis No.1 to No.8 (n=1 to 8)
)
Usable devices
MELSECNET/10
Indirectly
direct J \
specified
device
Bit Word
(Note) : Setting data except (S1) : Index qualification possible
(n1) (S1)
SP.CHGT
(n1)
S.CHGT (S1)
Description
(Note-1)
to execute the torque limit value change.
4 - 32
Special
Index
function
register
module
Z
U \G
: Usable
(S2) (D1)
(D2)
(S2) (D1)
(D2)
Constant
Other
K, H
: Usable partly
Data type
16-bit
binary
Character
sequence
16-bit
binary
Bit
16-bit
binary