Mitsubishi Electric Q172CPU Programming Manual page 579

APPENDICES
Table 2.6 Speed change/torque limit value change error (300 to 399) list
Control mode
Error
code
301
303
304
305
310
311
312
(4) Speed change/torque limit value change errors (300 to 399)
These are errors detected at speed change or torque limit value change.
The error codes, causes, processing and corrective actions are shown in Table
2.6 below.
The speed was changed for the axis during home
position return.
The speed was changed after positioning automatic
deceleration start.
The speed was changed during deceleration by
turning off the JOG start command signal
(M3202+20n, M3203+20n).
The speed after speed change is set outside the
range of 0 to speed limit value.
The absolute value of speed after speed change is
set outside the range of 0 to speed limit value.
The speed was changed during high-speed
oscillation.
The speed change to "0" was requested during
high-speed oscillation.
The value outside the range of 1 to 500[%] was set
in the torque limit value change request (CHGT).
The torque limit value change request (CHGT) was
made for the axis that had not been started.
Error cause
APP - 18
Error
Corrective action
processing
• Do not change speed during
home position return.
• Do not change speed after
Speed is
automatic deceleration start
not
for positioning control.
changed.
• Do not change speed during
deceleration by turning off the
JOG start command signal
(M3202+20n, M3203+20n).
• Set the speed after speed
change within the range of 0
Control
to speed limit value.
with the
• Set the absolute value of
speed limit
speed after speed change
value.
within the range of 0 to speed
limit value.
• Do not change speed during
Speed is
high-speed oscillation.
not
changed.
• Set the change request within
Torque limit
the range of 1 to 500[%].
value is not
• Request the change for the
changed.
starting axis.