Mitsubishi Electric Q172CPU Programming Manual page 312

7 MOTION PROGRAMS FOR POSITIONING CONTROL
G55
G56
G57
G58
G59
G61
G64
G90
G91
G92
G98
G99
G100
G101
For G43, G44, G49, G54 to G59, G90 and G91, use the currently selected modal group 01 to set the specifiable arguments.
(Note-1) : The G-code may be set in the first parameter only.
(Note-2) : The axis commands are X, Y, Z, U, V, W, A, B, CX, CY, CZ, CU, CV, CW, CA, CB, DX, DY, DZ, DU, DV, DW, DA, DB, EX, EY, EZ, EU, EV, EW, EA
and EB.
(Note-3) : The M-codes are except M00, M01, M02, M30, M98, M99 and M100.
Table 7.3 G-code arguments (Continued)
7 - 51
Only G-codes of G00, G01, G02, G03, G12, G13 and G92 are
(Note-1)
available.
Only G-codes of G00, G01, G02, G03, G12, G13 and G92 are
(Note-1)
available.
Only G-codes of G00, G01, G02, G03, G12, G13 and G92 are
(Note-1)
available.
Only G-codes of G00, G01, G02, G03, G12, G13 and G92 are
(Note-1)
available.
Only G-codes of G00, G01, G02, G03, G12, G13 and G92 are
(Note-1)
available.
Only G-codes of G00, G01, G02, G03, G12 and G13 are
(Note-1)
available.
Only G-codes of G00, G01, G02, G03, G12 and G13 are
(Note-1)
available.
Only G-codes of G00, G01, G02, G03, G12 and G13 are
(Note-1)
available.
Only G-codes of G00, G01, G02, G03, G12 and G13 are
(Note-1)
available.
Only G-codes of G00, G01, G02, G03, G12 and G13 are
(Note-1)
available.
: Must be specified : May be specified
Remarks
Blank : Must not be specified