Port 0 Worldwide Id - StorageTek L700 Service Manual

The Main Configuration Menu will appear and the cursor will line up with
LIBRARY CONFIG.
4. Press the
The Lib Config Menu will appear and the cursor will line up with LIB FIBRE I/F
CONFIG.
5. Press the
The Lib Fibre I/F Config Menu will appear and the cursor will line up with PORT 0
CONFIGURATION. This menu also displays the library's worldwide ID (the node
ID) and the Port 0 worldwide ID (the port ID). These two IDs are set at the factory
and cannot be changed. Each ID is 64 bits and uses the IEEE registered format.
6. Press the
The Fibre Port 0 Configuration menu will appear.
If you want to allow the network's software set the library Port 0 address, set the hard
address option to DISABLED by:
a. Pressing the arrow buttons until the cursor underscores AUTO ADDRESS.
b. Pressing the
c. Pressing the up and down arrow buttons to select DISABLED.
d. Pressing the
Note: The default for the hard address option is DISABLED.
If you want to set the library Port 0 address, you must set the HARD ADDRESS option
to ENABLED, enter a port address by:
a. Selecting ADDRESS from the Fibre Port 0 Configuration menu. The Port
b. Pressing the up and down arrow buttons to select a digit for each field in the
c. Pressing the
7. If the library Fibre Channel Port 0 address is the only configuration value you wish to
set at this time, press the
values before you reset the library, continue with the next section.

Port 0 Worldwide ID

When a library has a Fibre Channel interface, the Port 0 worldwide ID identifies the
library's Port 0 (that is, the lower MPU card) on the Fibre Channel system.
The ID is automatically displayed when you access the Fibre Channel Interface
Configuration Menu. It cannot be changed.
95846
button.
SELECT
button.
SELECT
button.
SELECT
button. The Port Hard Address Edit Menu.
SELECT
button to save the selected option.
SELECT
Address menu will display.
three-field address. Permissible addresses are 001 through 125.
button to save the address.
SELECT
RESET
Fourteenth Edition
StorageTek Proprietary
button. If you wish to set other configuration
Operator Panel Entry
2-25