Modes of Operation
Priority Mount Mode
The CSL is a sequential scratch loader. An operator can physically mount a
priority cartridge directly into the unit. The host may issue a Load Display
command with required volser. This command may be issued during any CSL
mode of operation informing the operator to place the cartridge into the feed
channel
Note: The output bin holds only seven cartridges. If you are going to load a
To mount a priority cartridge, review:
Figure 5-14. Priority Mounting a Cartridge
1. First index rod
2. Second index rod
3. Feed channel
CSL in System Mode
When the CSL is in the system mode and the drive is not loaded, follow these
procedures to load a priority cartridge:
1. Verify that the drive is currently unloaded and the index rods are on the
right
2. Insert the priority cartridge into the CSL feed channel
a. Insert the cartridge past the cartridge stop mechanism. See
b. Do not insert the cartridge past the first index rod
5-20
(Figure
5-14).
priority cartridge into the feed channel, ensure the output bin is
unloaded or has space for the priority mounted cartridge.
•
"CSL in System Mode"
•
"CSL in Automatic Mode" on page 5-21
•
"CSL in Manual Mode" on page 5-22
3
(Figure
5-14).
Sixth Edition
2
1
C53664
(Figure
5-14):
Figure
(Figure
5-15).
5-15.
95741