Modes of Operation
5. Unload the output bin when necessary.
Priority Mount Mode
The CSL is a sequential scratch loader. An operator can physically mount a
priority cartridge directly into the unit. The host may issue a Load Display
command with required volser. This command may be issued during any CSL
mode of operation informing the operator to place the cartridge into the feed
channel
Note: The output bin holds only seven cartridges. If you are going to load a
To mount a priority cartridge, review:
Figure 6-13. Priority Mounting a Cartridge
CSL in System Mode
When the CSL is in the system mode and the drive is not loaded, follow these
procedures to load a priority cartridge:
1. Verify that the drive is currently unloaded and the index rods are on the
right
2. Insert the priority cartridge into the CSL feed channel
6-18
(Figure
6-13).
priority cartridge into the feed channel, ensure the output bin is
unloaded or has space for the priority mounted cartridge.
•
"CSL in System Mode" on page 6-18
•
"CSL in Automatic Mode" on page 6-19
•
"CSL in Manual Mode" on page 6-19
FEED
CHANNEL
(Figure
6-13).
Ninth Edition
SECOND
INDEX
ROD
FIRST
INDEX
ROD
C53116
(Figure
6-13):
95739