Geofence" Command Index; Gps.geofence.park.set -Activates A Park Area; Gps.geofence.park.remove- Disables The Activated Park Area - FALCOM MAMBOII User Manual

C C
ONFIGURATION OMMAND
3.2.4.3
In order to have a basic understanding of conditional logic and geographic
coordinates, please refer to chapter 3.2.24, page
3.2.4.3.1
Command syntax
Examples
Responses
Command description
This command activates a park area (GF.0). The index of the park area is factory
predefined to 0. It places the MAMBOII (vehicle) into a circular park area, where
the current position (including Latitude and Longitude) of the MAMBOII is the
center of circle and the user specified
parameter) is the radius, in meter, of the circular area.
Parameter Description
none
Notes
•
The events GF.e0=inside and AREA.e0=inside are usually occurred from the
GPS.Geofence.Park.Set.
GPS.AREA.e0=inside) can be used to confirm the proper activation of the
park area.
•
This command only works if the device has a valid GPS position, because the
<p_value> for the circle is GPS-dependant (to know when the vehicle leaves
this circle).
•
If the MAMBOII device has got a valid GPS-fix, the GPS.GF.e0=inside and
GPS.AREA.e0=inside will occur indicating the park area is properly set.
• To deactivate the park area, use the GPS.Geofence.Park.Remove command.
•
This command will be written in the Flash memory, so even when the device
performs a reset, the park area will remain active until it is manually
deactivated. Whenever the system restarts, and the park area remains
active, the events GPS.GF.e0=inside and GPS.AREA.e0=inside are occurred
as soon as the MAMBOII receives valid GPS position.
3.2.4.3.2
Command syntax
Examples
Responses
Command description
This command removes an active park area (GF.0).
Parameter Description
none
Notes
This confidential document is a property of FALCOM and may not be copied or circulated without previous permission.
S - F R
ET IRMWARE

"Geofence" command index

GPS.Geofence.Park.Set –Activates a park area
$PFAL,GPS.Geofence.Park.Set
$PFAL,GPS.Geofence.Park.Set
E.g.
$park position set
$SUCCESS
OR
$error setting park position
$ERROR
GPS.Geofence.Park.Remove– Disables the activated park area
$PFAL,GPS.Geofence.Park.Remove
$PFAL,GPS.Geofence.Park.Remove
E.g.
$park position removed
2.4.0_ -
EVISION BETA
198.
//due to bad GPS coverage
<p_value>
Both events
V
ERSION
value (see GF.CONFIG
(GPS.GF.e0=inside
Page 98 of 271
1.0.0
and