Msg.send.csd,<Protocols>,<"Text"> - Redirects Command Responses To Csd Channel - FALCOM MAMBOII User Manual

C C
ONFIGURATION OMMAND
Parameter Description
<protocols>
It specifies the kind of protocols to be transmitted to the serial interface.
Supported protocols are listed in chapter page
formatted: starting with "$", ptotocol data, the checksum and closed by <CR><LF>.
<"text">
It specifies the text to be added to the selected protocols and transmitted to the
serial interface. The text is limited to
quotation marks (" ") even if there is no text specified. The text is sent out as is,
and not formatted (but if you want to use a "$" or <CR><LF> character as a
delimiter, just add at the end of user-text).
If you want to output also any system state (dynamic entry) when the command
is executed, the syntax of the
"text&(<entry
Each dynamic entry is separated by ampersand "&" without spaces and
enclosed in parentheses "( )".
The command for requesting such system states might look like this:
For example:
$PFAL,MSG.Send.RawSerial,0,"on
Dynamic entries are listed in chapter
Notes
•
In order to receive more than one protocol at once, you have to specify the
<protocols> in the hexadecimal value and add the corresponding hex value
of required protocols, for example:
➢
➢
•
The defined user protocols (in hexadecimal value) will be transmitted only
one time after request and not periodically.
•
The user text is sent first, followed by the protocols.
•
To switch off all protocols, set the <protocols> to 0.
3.2.7.1.3
Command syntax
Examples
Responses
Command description
Command responses are redirected to the CSD channel, unimportant from which
channel the command was received. The output text or dynamic entries
transmitted over a CSD call can be evaluated and used to control other devices
connected to remote modem. This command can be sent through Bluetooth, CSD
or TCP channel, but results are always routed to the remote modem via an
This confidential document is a property of FALCOM and may not be copied or circulated without previous permission.
S - F R
ET IRMWARE
<"text">
>)text&(<entry
1 2
The hex value
"$PFAL,MSG.Send.Serial,27,"test""
GGA+GSA+GSV+VTG protocols will be received at once,
The hex value
"$PFAL,MSG.Send.Serial,4F,"test""
GGA+GSA+GSV+RMC+IOP protocols will be received at once.
MSG.Send.CSD,<protocols>,<"text"> - Redirects command responses
to CSD channel.
$PFAL,MSG.Send.CSD,<protocols>,<"text">
,<protocols>,<"text
$PFAL,MSG.Send.CSD
$PFAL,MSG.Send.CSD,8,"MAMBOII outputs its GSP positions"
$PFAL,MSG.Send.CSD,0,"on
2.4.0_ -
EVISION BETA
. The transmitted protocols are
characters and it must be wrapped in
200
can be changed to:
>)text...&(<entry >)"
n
Time
&(Date) at &( ) it is moving at
6.2 page 243.
27 added
4F added
&(entry)">
&(Date) at &(Time) it is moving at
V
ERSION
&(Speed) m/s"
on the message
means the
on the message
means the
&(Speed) m/s"
Page 122 of 271
1.0.0