Display.alarm - Displays A Specific Alarm Image On The Screen - FALCOM MAMBOII User Manual

C C
ONFIGURATION OMMAND
Each dynamic entry is separated by ampersand "&" without spaces and it is
enclosed in parentheses "( )".
The command for requesting such system states might look like this:
For example:
$PFAL,Display.Dialog=10,"Speed Message",4,10,"Left","Right","on:
is moving at
Dynamic entries are listed in chapter
3.2.1.15.3 Display.Alarm – Displays a specific alarm image on the screen
Command syntax $PFAL,Display.Alarm=<image>,<timeout>,<"text">
$PFAL
$PFAL
Examples $PFAL,Display.Alarm=NEWSMS,20,"New SMS"
......
......
Responses E.g. $SUCCESS
Command description
This command enables you to display a specific alarm icon on the screen letting
the user know that something has happened (e.g., a specific event occurs,
receiving call, leaving/entering a geofence area etc.).
Parameter description
<image>
Specifies the image to be displayed on the screen. It can be set to:
Value
WARNING
CALL
NEWSMS
MAIL
KEYFOB
GEOFENCE
This confidential document is a property of FALCOM and may not be copied or circulated without previous permission.
S - F R
ET IRMWARE
&(Speed) m/s"
,Display.Alarm=WARNING,20,"Battery
,Display.Alarm=CALL,20,"Incoming call"
Meaning
Displays a warning image (e.g. when the battery
becomes low)
Displays a call image (e.g. when receiving a GSM call).
Displays an SMS image (e.g. when receiving an SMS).
Displays a mail image (e.g. when receiving a mail).
Displays a keyfob image (e.g. when a keyfob results
connected)
Displays a geofence image (e.g. when leaving/entering a
Geofence or Area).
2.4.0_ -
EVISION BETA
6.2 page 243.
low"
V 1.0.0
ERSION
&(Date) at &(Time) it
Page 67 of 271