C
C
ONFIGURATION
OMMAND
3.2.10.8 DEVICE.BAT.MODE
Parameter syntax
This parameter monitors the internal battery voltage. Based on the user specified
value, you may execute alarms (e.g. set the MAMBOII into a sleep mode) when the
battery drops to a minimum voltage (identified by the
<mode>
It determines whether or not the MAMBOII device will continue operating even if
the external power is disconnected. It can be set to:
Value
auto
disable
always
<min_charge>
Specifies the minimum voltage of battery power in volt at which the device will
generate
(Sys.Bat.eLow) is fired when the device is on battery power and the battery
voltage drops to user specified value. It can be set to a value from
By default, it is
How to set/get device configuration:
$PFAL,Cnf.Set,DEVICE.BAT.MODE=auto,3.7
Set configuration
$PFAL,Cnf.Get,DEVICE.BAT.MODE
Get configuration
Notes
•
In case of firmware update it is recommended to set this parameter to
DEVICE.BAT.MODE=auto
This confidential document is a property of FALCOM and may not be copied or circulated without previous permission.
S
- F
R
ET
IRMWARE
DEVICE.BAT.MODE=<>,<min_charge>
Meaning
Automatically switching between external power source
and internal battery power. If external power is removed
the power from the internal battery is automatically
supplied to your system. The system will see no interruption
of power and will continue to run. Once external power is
restored, the battery controller will use it to power your
system and recharge the batteries if needed. This setting
will prevent your system from shutting down when the
external power is removed.
Only external power will be used to power your system. If
the external power is removed your system will shutdown
automatically.
Your system will always be powered from the internal
battery. If external power is present, it will be used to
recharge the internal battery. Nevertheless, the external
power should always be applied in this mode.
a
Sys.Bat.eLow
3.55
V.
and then update the firmware as usual.
2.4.0_
-
EVISION
BETA
Sys.Bat.eLow
event
of
battery
V
ERSION
event).
low.
Low
battery
to
0
5
Page 150 of 271
1.0.0
event
Volts.
Need help?
Do you have a question about the MAMBOII and is the answer not in the manual?
Questions and answers