Gps.geofence.geostate,<Geo_Id> - Gets The State Of A Geofence; Gps.geofence.areastate,<Area_Id>- Gets The State Of An Area - FALCOM MAMBOII User Manual

C C
ONFIGURATION OMMAND
3.2.4.3.3
Command syntax
Examples
Responses
Command description
To read out the states of the created Geofence zones, whether the MAMBOII
device is inside or outside of the specified Geofence zone, use this command. To
configure/establish Geofencing use the
description of the
Parameter Description
<geo_ID>
Specifies the Geofence ID-number. Up to 100 Geofences are available. It can
be set to a value from
read.
3.2.4.3.4
Command syntax
Examples
Responses
Command description
To read out the state of an established area, whether the MAMBOII device is inside
or outside of the specified area, use this command. To configure/establish areas
use the parameter. Please, use the description of the parameter as a reference.
Parameter Description
<area_ID>
Specifies the ID-number of an area. It can be set to a value from
areas that are already established are readable.
This confidential document is a property of FALCOM and may not be copied or circulated without previous permission.
S - F R
ET IRMWARE
GPS.Geofence.GeoState,<geo_id> – Gets the state of a Geofence
$PFAL,GPS.Geofence.GeoState,<geo_ID>
$PFAL,GPS.Geofence.GeoState,1
e.g. $device is outside of GF1
parameter as a reference.
GF<id>
to 99. Only already established Geofencing can be
0
GPS.Geofence.AreaState,<area_id>– Gets the state of an Area
$PFAL,GPS.Geofence.AreaState,<area_ID>
$PFAL,GPS.Geofence.AreaState,1
e.g. $device is outside of AREA1
2.4.0_ -
EVISION BETA
parameter. Please, use the
GF<id>
V 1.0.0
ERSION
to 31. Only
0
Page 100 of 271