Command Types <C_Type; Aliases - FALCOM MAMBOII User Manual

C C
ONFIGURATION OMMAND
The example 6 above signifies that the device name is specified to "myMAMBOII".
The example 7 above signifies that the MAMBO II will beep, when left button (BTN0) is
short-pressed.
3.1.1.1
It is used to separate the huge amount of commands to different types. Currently the
following command types are available.
<c_type> Definition
Accomplishes a predefined set of system tasks such as:
System management tasks, including:
- Reset,
Sys
Initialization/interruption of system processes, including:
The operating firmware provides parameters that can be set/changed or read. Based on the
Cnf
parameter-settings some events will be occurred.
Accomplishes a predefined set of system peripheral commands allowing access to the LEDs, Beep
IO
tones generation and Vibrating alerts.
Accomplishes a predefined set of GPS tasks including navigation, history logging and geo-fences
GPS
and areas.
Accomplishes a predefined set of GSM tasks including SMS, voice and data calls, GPRS services
GSM
etc.
Accomplishes a predefined set of TCP connection tasks including connecting disconnecting and
TCP
sending of TCP packets to the predefined address of remote server etc.
Accomplishes a predefined set of output messages (GPS protocols) allowing information to be
MSG
transmitted across the serial interface, CSD network or Internet (TCP).
Accomplishes a predefined set of IEEE tasks on the device as well as provides parameters to
IEEE
connect the IEEE devices (Keyfob + I/O-BOX) to the MAMBOII.

3.1.2 Aliases

This PFAL command specifies the alias names for all available <c_type>, <c_index>,
<c_subindex>.
Following aliases are defined as default:
Sys is the alias name of
Cfg is the alias name of
if an alias has been specified, it can be freely used instead of the original word (or
number). To specify alias names, please refer to the chapter
Notes
• To avoid misinterpretation about using alias names, please assure that no
equal or very similar aliases are used inside the same command type/index.
• Also avoid starting of alias with numbers as they might be misinterpreted as
original index numbers.
This confidential document is a property of FALCOM and may not be copied or circulated without previous permission.
S - F R
ET IRMWARE
Command types <c_type>
- Shutdown/power management etc.
- Timers,
- Counters etc.
Table 2: Supported command types
System
Config
2.4.0_ -
EVISION BETA
<c_type>
.
V
ERSION
page
3.2.17.1 172.
Page 22 of 271
1.0.0