History" Command Index; Gps.history.write,<Flag>,<"Text"> - Stores Gps Data Or User Text In The History Memory - FALCOM MAMBOII User Manual

C C
ONFIGURATION OMMAND
3.2.4.2
The GPS satellites are continuously transmitting a radio message containing information,
including when the data was sent. When the GPS receiver fitted in the vehicle is
powered on, through the connected GPS antenna, it receives continuously the radio
messages sent from satellites containing GPS information the sent data. The received
information from at least 4 satellites will be computed and carried out the necessary
calculations to determine its current position. This data solution can be stored in the on-
board Flash memory for further evaluation.
The History functions enable the MAMBOII device to store the position and time into the
history storage space (a portion of FLASH which uses 960 Kbytes memory size). When
the MAMBOII unit has obtained a GPS Fix, it is capable of saving up to 245.715 position
records in its history memory space. The History function works on what is called a FIFO
principal: First in, first out, it means when the memory space has been used up, the
oldest records will automatically be deleted to make space for new incoming data.
3.2.4.2.1
Command syntax
Examples
Responses
Command description
This command records a new GPS position entry (including current position, speed,
number of satellites and time) into the history memory space. Additional
information can be attached to each entry, if the <flag> and <"text"> parameters
are defined. Entries can be written without having a valid GPS fix (i.e. store user
messages, IN/OUT states or other additional information).
Parameter Description
<flag>
It determines whether or not additional information has to be stored in the history
memory. Following are listed for additional information in hexadecimal value
(specify it excluding "0x"):
Value
0x00
0x01
0x02
0x04
0x08
0x10
0x20
This confidential document is a property of FALCOM and may not be copied or circulated without previous permission.
S - F R
ET IRMWARE

"History" command index

GPS.History.Write,<flag>,<"text"> – Stores GPS data or user text in the
history memory
$PFAL,GPS.History.Write,<flag>,<"text">
$PFAL,GPS.History.Write,20,"enter_the_text_to_be stored"
$PFAL,GPS.History.Write,40,""
$PFAL,GPS.History.Write,0,""
E.g
$SUCCESS
Meaning
Writes the current GPS position of the device.
Writes the current state of the Iinput and Output.
Writes the current state of the GSM (field strength, cell id,
area code, of incoming/outgoing SMS etc.)
Writes the current operating mode of the system, GPRS,
PPP, TCP, system lifetime.
reserved.
Writes the current analog values (for FALCOM devices
that have analog inputs only) .
Writes the specified text from the <"text"> field (up to 99
characters available)
2.4.0_ -
EVISION BETA
V 1.0.0
ERSION
Page 89 of 271