Msg.mode.tcp=<Out_Sys_Messages>,<Mode> - Defines The Communication Mode On Tcp Channel - FALCOM MAMBOII User Manual

C C
ONFIGURATION OMMAND
Notes
• In order to deliver more than one system message at once, specify the sum
determined by adding the corresponding hex value of each system status, for
example:
− the hex value
delivered all others are disabled.
•
The default setting of the
system-related messages are disabled. Means, no system messages will be
transmitted from the MAMBOII unit over CSD channel. However, only PFAL
commands are accepted.
•
Please note that, changes to these settings may set the MAMBOII device in a
mode where it can only be reconfigured via SMS. If the SMS communication is
disabled, the system cannot be reconfigured anymore. A Firmware update is
necessary to exchange information (enable communication) with it again.
3.2.7.2.3
Command syntax
Examples
Responses
Command description
This command defines the communication mode that will be used when the
MAMBOII receives a message/command from the TCP channel. It also defines
whether any system-related message will be periodically transmitted to the
redirected channel. This command does not affect the configuration of
DEVICE.COMM.TCP.CLIENT
long as the internal firmaware is running. Once the device performs a reset, the
configuration of
Parameter Description
<out_sys_messages>
It specifies the kind of system messages to be transmitted to the redirected
channel <msg_out_chan>. Add the sum or one hexadecimal number
corresponding to the message to be transmitted without leading "0x".
Value
0x01
0x02
0x04
This confidential document is a property of FALCOM and may not be copied or circulated without previous permission.
S - F R
ET IRMWARE
continuously through the specified <msg_out_chan>
channel. See also chapter
<msg_out_chan>
Specifies the channel to redirect the data. It can be set to
(without leading "0x"):
0x01
0x02
0x04
C means: GPEVENT + GPACTION of system status will be
DEVICE.COMM.CSD
MSG.Mode.TCP=<out_sys_messages>,<mode>
communication mode on TCP channel
$PFAL,MSG.Mode.TCP
<out_sys_messages>,<mode>
$PFAL,MSG.Mode.TCP=
$PFAL,MSG.Mode.TCP
$PFAL,MSG.Mode.TCP=0,C
$PFAL,MSG.Mode.TCP=0,D=4
E.g.
$TCP: mode=cmd, output=0
parameter. Results to this command are available as
DEVICE.COMM.TCP.CLIENT
Meaning
Transmits GPSTATE.
Transmits GPERROR.
Transmits GPACTION.
2.4.0_ -
EVISION BETA
6.8, page
Redirects data to the serial channel.
Redirects data to the CSD channel.
Redirects data to the TCP channel.
is "cmd,0", signifying that the
parameter will be used.
V
ERSION
259 as a reference.
- Defines
Page 128 of 271
1.0.0
the