FALCOM MAMBOII User Manual page 126

C C
ONFIGURATION OMMAND
0x01
0x02
0x04
0x08
<mode>
MAMBOII supports and operates in two communication modes, the Command
and Data mode. In Command mode set to "C", it waits for PFAL commands. In
Data mode set to "D=<msg_out_chan>", all received commands/messages (any
text) are redirected as they are without processing any of them to redirection
channel <msg_out_chan>. The <mode> defines the communication mode to be
used on this channel. It can be set to:
Value
C
D=<msg_out_chan>
Notes
•
To deliver more than one system-related message <out_sys_messages> at
once, specify the sum determined by adding the corresponding hex value of
each system status, for example:
− the hex value
delivered all others are disabled.
•
The default setting of the
system-related messages are enabled. Means, that all system messages will
be transmitted every second from the MAMBOII unit through serial interface.
However, only PFAL commands are accepted.
•
Please note that, changes to these settings may set the MAMBOII device in a
mode where it can be just reconfigured via SMS. If the SMS communication is
also disabled, the system cannot be reconfigured anymore. A Firmware
This confidential document is a property of FALCOM and may not be copied or circulated without previous permission.
S - F R
ET IRMWARE
Transmits GPSTATE.
Transmits GPERROR.
Transmits GPACTION.
Transmits GPEVENT.
Meaning
Places the serial channel in command mode. Everything
sent to the MAMBOII through this interface will be
processed as a PFAL command. Responses to the sent
command are also returned through the serial interface.
However, if <out_sys_messages> is greater than 0, all
selected messages will be continuously output through
this interface.
Places the serial channel in data mode. Everything
sent to the MAMBOII through this interface is redirected to
the specified channel <msg_out_chan> without processing
any of them. In this mode user messages without leading
"PFAL" can be used. However, if <out_sys_messages> is
greater than 0, the selected messages will be transmitted
continuously
channel. See also chapter
<msg_out_chan>
Specifies the channel to redirect the data. It can be set to
(without leading "0x"):
0x00
0x01
0x02
0x04
C means: GPEVENT + GPACTION of system status will be
DEVICE.COMM.SERIAL
2.4.0_ -
EVISION BETA
through the specified
6.8, page
Data is not redirected somewhere (this data
could be done via alarms now using the
dynamic entry
&SerialData
Redirects data to the serial channel.
Redirects data to the CSD channel.
Redirects data to the TCP channel.
is "cmd,F", signifying that the
V
ERSION
<msg_out_chan>
259 as a reference.
).
Page 126 of 271
1.0.0