Counter" Command Index; Sys.counter<Index>.Set=<Value> - Sets Counters To A Value - FALCOM MAMBOII User Manual

C C
ONFIGURATION OMMAND
Notes
•
Alias
ALIAS.STORAGE<storage_index>=<alias_name>. Read also the description of
storage index given in the table of abbreviations.
3.2.1.6
Counters are user-based counters, which allow you a limitation of automatically alarms
at which a counter reaches its minimum value zero (0) or the defined value in your
application. You can then handle this event (see chapter 3.2.25.1.1.2.5, page
execute specific alarms you need. You could use a counter to execute limited alarms,
for example, 10 alarms. See examples in chapter 6.11.3.3, page
be:
 set,
 incremented,
 decremented,
 requested (its state),
 saved,
 loaded,
 cleared.
3.2.1.6.1
Command syntax
Examples
Responses
Command description
To define the value of a Counter<index>, use this command. It is the start value
from which the increment and decrement commands initiate their count up and
down method.
Parameter description
<index>
Determines the index of the counter to be set. Up to 20 Counters are available. It
can be set to a value from
<value>
32-bit integer value from
Counter<index>.
This confidential document is a property of FALCOM and may not be copied or circulated without previous permission.
S - F R
ET IRMWARE
names can be

"Counter" command index

Sys.Counter<index>.Set=<value> – Sets Counters to a value
Sys.Counter<index>.Set=<value>
$PFAL,Sys.Counter0.Set=1000
E.g.
$Counter 0 set to 1000
OR
$Counter 0 set to -100
to 19.
0
0
2.4.0_ -
EVISION BETA
defined for all storage
//The value range exceeded
to 2147483647. Sets the value of the specified
V 1.0.0
ERSION
indices by using
214) to
266. Each counter can
Page 52 of 271