Sys.device.clearalarm - Clears Existing Alarms And Restart The Device; Sys.device.clearconfig - Clear Existing Configuration; Sys.device.cfgupdatemode - Prevents Interferences Between Old And New Alarms - FALCOM MAMBOII User Manual

C C
ONFIGURATION OMMAND
3.2.1.3.6
Command syntax
Examples
Responses
Command description
This command clears all user-set alarms and restarts the system when this command
is successfully processed.
Parameter description
None
3.2.1.3.7
Command syntax
Examples
Responses
Command description
The MAMBOII device has the option to clear all user-specified configuration and to
restart the system when the clear command is successfully processed. Default
settings (see chapter
Parameter description
None
3.2.1.3.8
Command syntax
Examples
Responses
Command description
This command enters the device into a special configuration update mode, which
is recommended during alarm configurations. This mode prevents the interferences
between old and new alarms.
When being inside this mode:
- All configured alarms become inactive
- The configured Macros can be directly executed via PFAL commands.
Parameter description
None.
Notes
• To exit the configuration update mode, a system reset is required
• This mode can also be used to test the alarm conditions and simulate step by
step usual alarm behaviour:
 Events will be displayed
 Alarm states can be checked using the MSG.Info.Alarm command
This confidential document is a property of FALCOM and may not be copied or circulated without previous permission.
S - F R
ET IRMWARE
Sys.Device.ClearAlarm – Clears existing alarms and restart the device
Sys.Device.ClearAlarm
$PFAL,Sys.Device.ClearAlarm
-
Sys.Device.ClearConfig – Clear existing configuration
Sys.Device.ClearConfig
$PFAL,Sys.Device.ClearConfig
-
6.9 on page 260) remain available.
Sys.Device.CfgUpdateMode – Prevents interferences between old and
new alarms
Sys.Device.CfgUpdateMode
$PFAL,Sys.Device.CfgUpdateMode
-
2.4.0_ -
EVISION BETA
V 1.0.0
ERSION
Page 42 of 271