Ieee.iobox<Cnf_Ib_Div_Index - FALCOM MAMBOII User Manual

C C
ONFIGURATION OMMAND
How to set/get IO configuration:
$PFAL,Cnf.Set,IEEE.KEYFOB0=0,0013450100000075
Set configuration
$PFAL,Cnf.Set,IEEE.KEYFOB1=0,0013450100000076
$PFAL,Cnf.Get,IEEE.KEYFOB0
Get configuration
$PFAL,Cnf.Get,IEEE.KEYFOB1
Notes
To delete an existing index, set the MAC address to zero, for example:
•
PFAL,Cnf.Set,IEEE.KEYFOB0=0,0000000000000000.
Disable
•
PFAL,Sys.IEEE.[Disable,Enable]
configuration completes.
3.2.12.3 IEEE.IOBOX<cnf_ib_div_index>
Parameter Syntax
This parameter allows you to make an IEEE connection to an I/O-BOX and to
request the status of analog and digital inputs. MAMBOII device is configured to
start the IEEE 802.15.4 network and will serve as the PAN coordinator in that network.
See chapter
<cnf_ib_div_index>
It specifies the index from 0 to 5 of the I/O-BOX being connected. The index
differentiates similar I/O-BOX devices from each other. Up to 6 IEEE enabled
devices (Keyfobs + I/O-BOXes) are supported by the MAMBOII. Depending on
your requirements you may connect
index is entered, the device will return an error. To configure Keyfobs, refer to the
parameter "IEEE.KEYFOB<index>".
<sec_mode>
Because many devices might connect over a wireless IEEE connection and get
the data that is transmitted from, this setting specifies the type of connection
security. It can be set to:
Value
0
1
<in_report_mode>
It defines the mode for requesting the status of the digital inputs operation. It
can be set to:
Value
0
This confidential document is a property of FALCOM and may not be copied or circulated without previous permission.
S - F R
ET IRMWARE
Figure 4: Shows the location of the Keyfob's MAC address
and Enable
<cnf_ib_div_index>=<sec_mode>,<in_report_mode>,<in_inval>,<ana_rep
IEEE.IOBOX
ort_mode>,<ana_inval>,<address>
as reference.
4.3
Meaning
Disables encrypted transmissions.
Enables encrypted transmissions (currently not implemented).
Meaning
No status request.
2.4.0_ -
EVISION BETA
IEEE chip inside
accordingly)
2 Keyfobs and
V
ERSION
manually
after your IEEE-specified
I/O-BOXes. If an incorrect
4
Page 164 of 271
1.0.0
(using