Mode" Command Index; Channel - FALCOM MAMBOII User Manual

C C
ONFIGURATION OMMAND
3.2.7.2
All three commands within this chapter can be used to disable temporarily the function
of the
DEVICE.COMM.SERIAL, DEVICE.COMM.CSD
parameter and to define a new communication mode until the MAMBOII unit restarts.
Following communication modes can be defined: Command or Data mode. The
configuration settings to theses Command is dynamically, which means that this
configuration is stored in the SRAM and not in the FLASH. So, whenever the device
performs a reset, this configuration is lost and the communication mode is read from
the
DEVICE.COMM.SERIAL,
parameter respectively. The execution of these commands does not affect/change
the configuration on the above-mentioned parameters.
These modes are valid only for incoming commands/messages/data from the
corresponding channel and not when a command is executed by the system MAMBOII
as an alarm (AL).
For example,
If the MSG.Mode.TCP communication mode is defined to Data, then all
commands
$PFAL,MSG.Send.TCP,8,"MAMBOII outputs its GSP positions") are not
processed by the system, but directly returned back to the remote server as
they are.
The data mode can be used to read the data from external devices connected to the
MAMBOII (for example, a Bluetooth barcode scanner connected to a MAMBOII
device).
3.2.7.2.1
Command syntax
Examples
Responses
Command description
This command defines the communication mode that will be used when the
MAMBOII receives a message/command from the serial channel. It also defines
whether any system-related message will be periodically transmitted to the
redirected channel. This command does not affect the configuration of
DEVICE.COMM.SERIAL parameter. Results to this command are available as long
as the internal firmware is running. Whenever the device performs a reset, the
configuration of DEVICE.COMM.SERIAL parameter will be used.
Parameter Description
out_sys_messages
<
It specifies the kind of system messages to be transmitted to the redirected
channel <msg_out_chan>. Add the sum or one hexadecimal number
corresponding to the message to be transmitted without leading "0x".
Value
This confidential document is a property of FALCOM and may not be copied or circulated without previous permission.
S - F R
ET IRMWARE

"Mode" command index

DEVICE.COMM.CSD
if the MSG.Mode.TCP communication mode is defined to Command,
then all commands
$PFAL,MSG.Send.TCP,8,"MAMBOII outputs its GSP positions") are
processed by the system and results are returned back to the remote
server.
sent from
MSG.Mode.Serial=<out_sys_messages>,<mode>-
communication mode on serial channel
$PFAL,MSG.Mode.Serial
$PFAL,MSG.Mode.Serial=
$PFAL,MSG.Mode.Serial
$PFAL,MSG.Mode.Serial=F,C
$PFAL,MSG.Mode.Serial=0,D=4
E.g.
$Serial: mode=cmd, output=F
>
Meaning
2.4.0_ -
EVISION BETA
or
or
sent from the
the remote
<out_sys_messages>,<mode>
V
ERSION
DEVICE.COMM.TCP.CLIENT
DEVICE.COMM.TCP.CLIENT
remote server
server
Defines
Page 125 of 271
1.0.0
(e.g.
(e.g.
the