Macro" Command Index; Sys.macro<Index>- Activates Configured Macros - FALCOM MAMBOII User Manual

C C
ONFIGURATION OMMAND
3.2.1.7
3.2.1.7.1
Command syntax
Examples
Responses
Command description
This command is intended to activate a configured Macro. To configure a Macro,
please refer to the corresponding index of the parameter (MACRO<index>). Using
of different indices enable you to execute up to 50 commands set into a single
alarm (AL). How to set a Macro refer to the chapter
Parameter description
<index>
Determines the index of the macro to be activated. Up to 20 macros are
available for use. It can be set to a value from
Notes
•
The command does not directly execute a macro several times, even if the
macro is activated, e.g. by an event, it will execute the Marco just once.
•
Of course, a macro can be executed several times, but the time between 2
macro activations depends on how much time the macro needs to execute
all set commands before it will be reactivated.
•
If the time-span between two macro activations is too short, then only a part
of set commands within a macro might be executed twice.
This confidential document is a property of FALCOM and may not be copied or circulated without previous permission.
S - F R
ET IRMWARE

"MACRO" command index

Sys.Macro<index>– Activates configured Macros
Sys.Macro<index>
$PFAL,Sys.Macro0
E.g.
$activate macro 0
2.4.0_ -
EVISION BETA
3.2.25.1.1.9.3
to 19.
0
V 1.0.0
ERSION
page 233.
Page 56 of 271