How To Connect An I/O-Box Device To The Mamboii; How To Connect A Bluetooth Audio Headset To The Mamboii - FALCOM MAMBOII User Manual

C C
ONFIGURATION OMMAND
into the GSM network -
device (if required)
$PFAL,GSM.PIN="1111"
$PFAL,Sys.Device.Reset
and then send the configuration (AL5) to the device
$PFAL,Cnf.Set,AL5=GPS.Nav.eFix=valid:GSM.SMS.Send,"+4912345678",03,"MAMBOII's positions"
However, you determine how or whether to process an event.

4.3.3 How to connect an I/O-BOX device to the MAMBOII

Connecting a I/O-BOX device in two-step process (use Figure 12 as a reference):
1. Perform the steps 1.. 7 as given in chapter
2. To enable MAMBOII to communicate with I/O-BOX, the MAMBOII must know the
address of the I/O-BOX device. Therefore, you need only to load the following
configuration into the MAMBOII device.
a) Specify the network identifier (if not yet specified).
Set configuration
b) Connect I/O-BOX to the MAMBOII. The last entry in the following command
specifies
figure 5). This address is available on the sticker on the back of the
all 16- digits of this address.
Set configuration
c) Copy the configuration above, past them on the Editor
sending configuration
Editor
➒
d) Power up the I/O-BOX device. I/O-BOX
supply power to the device.
e) When the I/O-BOX is successfully connected to the MAMBOII-device, the event
"
$GPEVENT:IEEE.IOBox0.State.eConnected
4.3.4

How to connect a Bluetooth audio headset to the MAMBOII

Connecting a Bluetooth audio headset in twelve-step process (use Figure 12 as a
reference):
1. Perform the steps 1.. 7 as given in chapter
2. Copy the configuration command given below, past it on the Editor
to MAMBOII either by clicking on "Start sending configuration"
with left mouse on this command text.
Set configuration
3. Because the Bluetooth protocol resets when the configuration above is sent to the
MAMBOII device, you need to reconnect the MAMBOII device with the Bluetooth
software.
4. Later on, set your headset into the pairing mode (for more details, refer to the User's
manual of the headset and find out how to set the headset into the pairing mode).
This confidential document is a property of FALCOM and may not be copied or circulated without previous permission.
S - F R
ET IRMWARE
firstly enter the correct PIN code of the used SIM card, reset the
$PFAL,Cnf.Set,IEEE.PANID=CAF0
the MAC address of the I/O-BOX, which is unique to each
$PFAL,CNF.Set,IEEE.IOBOX0=0,2,0,2,F,0017920030000DA8
➓
or double
to sent them separately.
$PFAL,Cnf.Set,DEVICE.BT.AUDIOGW=0,8888
2.4.0_ -
EVISION BETA
as follow:
page
4.3.1 236.
click each command/configuration on the
will be powered automatically when you
will be displayed
"
page
4.3.1 236
V
ERSION
I/O-BOX (see
I/O-BOX
and then click on Start
➒
on the Console1
,
➒
and send it
➓
or double click
Page 238 of 271
1.0.0
. Enter
➍