FALCOM MAMBOII User Manual page 30

C C
ONFIGURATION OMMAND
PFAL COMMAND SET
$PFAL,MSG.Version.HardwareRev
$PFAL,MSG.Version.Hardware
$PFAL,MSG.Version.Software
$PFAL,MSG.Version.SoftwareID
$PFAL,MSG.Info.ServerLogin
$PFAL,MSG.Info.Protocol,<protocols>,<"text">
$PFAL,MSG.Info.Time
$PFAL,MSG.Info.Alarm,<alarm_index>
$PFAL,MSG.Channel.SerialGSM
IEEE commands
$PFAL,IEEE.Keyfob<kf_div_index>.LED<lindex>=<config_t
ype>
$PFAL,IEEE.Keyfob<kf_div_index>.Beep=<config_type>
$PFAL,IEEE.Keyfob<kf_div_index>.Vibration=<config_type
>
$PFAL,IEEE.IOBox<ib_div_index>.OUT<oindex>=<config_t
ype>
$PFAL,IEEE.IOBox<ib_div_index>.power=<power_mode>
$PFAL,IEEE.IOBox<ib_div_index>.bat.level
Bluetooth-Audio commands
$PFAL,BT.Audio.Bound
$PFAL,BT.Audio.Connect
$PFAL,BT.Audio.Disconnect
This confidential document is a property of FALCOM and may not be copied or circulated without previous permission.
S - F R
ET IRMWARE
Table 5: Complete list of PFAL commands.
2.4.0_ -
EVISION BETA
MEANING
Retrieves the hardware revision of the PCB
Retrieves the hardware version of the target device
Retrieves the software version of the target device
Retrieves the software ID
Identifies the device to the FALCOM's Server
Transmits the selected protocols to the sender
Retrieves the current system time
Transmits the selected alarm to the sender
Channels messages from serial port directly to GSM
engine
Sets and controls LED blinking to a Keyfob
Sets and controls the Beep tones to be generated
on a Keyfob.
Sets the type of vibration alert on a Keyfob
Configures the outputs on an I/O-BOX
Set the operation mode on an I/O-BOX
Gets battery charge state
Pairs Bluetooth audio devices
Places both Bluetooth devices in the connection
mod
Closes a currently open audio connection
V 1.0.0
ERSION
Chapter
3.2.7.3.4
3.2.7.3.5
3.2.7.3.6
3.2.7.3.7
3.2.7.4.1
3.2.7.4.2
3.2.7.4.3
3.2.7.4.4
3.2.7.5.1
3.2.8.1.1
3.2.8.1.2
3.2.8.1.3
3.2.8.2.1
3.2.8.2.2
3.2.8.2.3
3.2.9.1.1
3.2.9.1.2
3.2.9.1.3
Page 30 of 271