Service Test - Centrecom FS980M/9 Command Reference Manual

I T C
NTERFACE ESTING OMMANDS

SERVICE TEST

service test
Overview This command puts the device into the interface testing state, ready to begin
testing. After entering this command, enter Interface Configuration mode for the
desired interfaces and enter the command
Do not test interfaces on a device that is part of a live network—disconnect the
device first.
Use the no variant of this command to stop the test service.
service test
Syntax
no service test
Mode Global Configuration
Example To put the device into a test state, use the command:
awplus(config)#
Related test interface
Commands
613-50137-01 Rev A
service test
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.6-2.x
test interface.
338